Chapter 3 Various Processes During Pwb Production; When Components Run Out (If The Check Box "Stop System When Components Run Out" Is Checked On The "Operation Option" Screen) - JUKI KE-2070 Operation Manual

Operation manualⅠ
Chapter 3
This Chapter describes how to handle main errors that will occur during PWB production
and a component run-out error.
3.1 When components run out (If the check box "Stop system when
components run out" is checked on the "Operation option" screen)
Immediately after components run out, the following screen appears and the machine
stops temporarily.
After replenishing the machine with components or removing the cause of
a component run-out error (such as jamming of tape), select the <Retry>
button, and then press the <START> switch.
When you press the <CAMERA> button of the HOD while the machine stops because
components run out, you can recheck the pick-up position where a component run-out
error occurred. If a component pick-up error is serious, perform a teaching operation
again.
Various Processes During PWB
Production
Error screen
How to handle an error
This button makes the machine skip the placement position at which
components run out to pick up the next component to be placed.
Use this button when you do not have components at hand.
Immediately after the machine finishes placing the components that
can be placed on boards, it pauses again.
Causes of the error
① The stocked components run out.
② The machine failed to pick up a
component.
(Due to jammed peel-off tape or a
pick-up position error caused by
defective tape feeding)
3− 1