DANGER
[7]
ATC
After the ATC base has been replaced, it is necessary to obtain "ATC Offset" of the MS
parameters again. (See also section 4-7, in MS parameters.)
7-1. Replacing the Air Cylinder
1) Close the hand valve at the lower left portion of the main unit.
2) Remove the ATC joint and Hexagon socket head cap screw to detach the air cylinder.
(At this time, disconnect the φ4 air tube.)
3) Mount the speed controller on a new air cylinder.
Hexagon socket
head cap screw
ATC joint
Maintenance Guide
To prevent any trouble caused by accidental machine start, always
shut-down the power before starting the maintenance and
adjustment work.
Air cylinder
Figure 7-1-1 Replacing the Air Cylinder
Speed controller
7-1
Rev. 2.0