Adjusting The Sensor Height - JUKI KE-3010 Maintenance Manual

3-2-2. Adjusting the Sensor Height

Move the bad mark sensor to a point above the calibration block. Loosen the SEMS cap bolts at
two places and move the BMR lens bracket so that the distance between the surface of the bad
mark sensor and the top surface of the calibration block becomes 28
After the sensor height has been adjusted, secure the bad mark sensor with SEMS cap bolts.
After the bad mark sensor has been mounted properly, input the bad mark sensor offset of the
MS parameters.
(For details about how to input MS parameters, see "MS Parameters".)
CAUTION
Maintenance Guide
CAL block
top surface
Figure 3-2-2-1 Adjusting the Lens Height
To prevent any personal injury, do not put your hand inside the
machine or your face or head close to the machine during operation
of the touch panel and/or HOD.
HMS
SEMS cap
3-4
Rev. 1.0
+0.5 mm.
0
BM