JUKI KE-3010 Maintenance Manual page 157

5-7-3-2. Replacement
5-7-3-2-1. Assembling the Fiber into the Amplifier
1) Raise the lever on the top of the amplifier unit.
2) Insert the fiber into the amplifier unit completely until it is in contact with the far position, and
then lay down the lever.
∗ Assemble the light emitting side and light receiving side correctly without fail.
∗ Cut the top end with the cutter supplied with the fiber and insert the fiber sensor into the
amplifier.
Light emitting side
Light receiving side
5-7-3-2-2. Detaching and Attaching the Amplifier Unit
1) Push in the amplifier unit toward the fiber insertion side.
2) Raise the fiber insertion side with the amplifier unit kept pushed. The amplifier is then
detached.
3) When attaching the amplifier unit, hang the claw on the cable side on the DIN rail and push in
the fiber insertion side downward.
4) For details about fiber amplifier attaching order, see Figure 5-7-3-2-2-2.
Maintenance Guide
投光
受光
Figure 5-7-3-2-1-1
②
Figure 5-7-3-2-2-1
40092570
40092571
40092572
WAIT SENSOR ASM
STOP SENSOR ASM
C.OUT SENSOR ASM
5-16
Rev. 2.0
①