JUKI KE-3010 Maintenance Manual page 220

<Preparation for making a change for the XL specification>
∗ In the case of the electric bank specification, remove the cutter unit according to the previous
item "Changing the cutter unit."
1) Turn off the power supply and make sure that the vacuum pump is not in operation.
(After the pump is operated, its inside is hot. Leave it for about 30 minutes after it is stopped,
and then start operations after making sure that the pump is cooled down.)
2) Remove the covers on both front side
3) Remove the vacuum pump cover on the front side.
4) Remove the air tube harness (power ground wire).
5) Remove the circular screws
6) Loosen the flange nuts
Front side
7) Pull out the vacuum pump from the front side. (Pay attention to the harness when pulling it
out.)
Maintenance Guide
and rear side
Cable band
Air tube removing position
that fix the vacuum pump plate.
on the rear side that fix the vacuum pump plate.
10-9
.
Rear side
Front side
Rear side
Rev. 2.0