JUKI KE-3010 Maintenance Manual page 320

14-3-5. ETHER-MAIN Board (40048066)
[Functions]
This ETHER-MAIN board is a host board used
to communicate with the ETHER-SLAVE board
through the Ethernet.
The board is connected to the Compact PCI
(hereafter referred to as "cPCI") bus so as to
access each peripheral I/O from the CPU board.
Additionally, the MS parameter backup data is
saved into the FLASH ROM.
[DIP-switch settings]
The DIP-switches have been set properly at the delivery of the machine. When setting the
board in the control unit, check the DIP-switch settings. ( portions show the switch positions.)
Figure 14-3-5-1 DIP-Switches on ETHER-MAIN Board Assembly
[Meaning of LED]
7-segment LED: Shows the operation status of this board.
RUN LED: Lights up when the power is supplied.
Shows Link/Act of EN1. EN1 → Left station
EN1:
Shows Link/Act of EN2. EN2 → Right station
EN2:
Shows Link/Act of EN3. EN3 → S-XY-RELAY board – BASE CARRY board –
EN3:
EN4: Shows Link/Act of EN4.
[Adjustment items after replacement]
After that, follow the steps below to update the FLASH memory.
Select [Options] and [Change User Group], and then select [Serviceman].
Select [Maintenance] and [MS Parameter Setup].
Select [Upgrade] and [Ether Main].
Clicking [Exec.] will start the upgrading process.
Maintenance Guide
SW2-1 ：OFF
SW2-2 ：ON
SW2-3 ：OFF
SW2-4 ：OFF
SW2-5 ：ON
SW2-6 ：ON
SW2-7 ：ON
SW2-8 ：ON
SW1-1 ：OFF
SW1-2 ：OFF
SW1-3 ：ON
SW1-4 ：OFF
FEEDER board
14-23
SW4-1 ：OFF
SW4-2 ：OFF
SW4-3 ：OFF
SW4-4 ：OFF
SW4-5 ：OFF
SW4-6 ：OFF
SW4-7 ：OFF
SW4-8 ：OFF
SW5：OFF
Rev. 2.0