Transport Unit; Structure Of Transport Unit - JUKI KE-3010 Maintenance Manual

14-7. Transport Unit

14-7-1.

Structure of Transport Unit

Table 14-7-1-1 shows the structure drawing of the transport unit.
Mount the BASE I/O board on the left of the front below the board base frame and the driver for
the transport stepping motor and the driver for the support table stepping motor on the right of the
rear on the base frame.
The support table is also called "BU (backup table)".
It is not necessary to change the connection destination boards of the transport L motor, transport
R motor, transport L sensor, transport R sensor, and WAIT sensor inside the transport unit
according to the reference and flow direction.
１
４
１
1 Transport L motor (stepping motor)
Transport CENTER motor (stepping motor)
Transport R motor (stepping motor)
Transport L sensor
WAIT sensor
STOP sensor
C/OUT sensor
Transport R sensor
Stopper
Y pusher
Support table motor (stepping motor)
11
BU origin sensor
12
Maintenance Guide
10
Ａ
５
Figure 14-7-1-1 Transport unit
14-35
１2
９
１1
６ ７
Rev. 2.0
２ ３
８
２ ３