Replacing The T-Pin Sensor (Optional) - JUKI KE-3010 Maintenance Manual

5-10. Replacing the T-PIN Sensor (Optional)

1) Remove the adjustment screw to detach the sensor bracket and replace the sensor.
When reassembling the components, adjust the position of the sensor bracket by loosening
the adjustment screw and moving the sensor bracket up and down so that the T-PIN sensor is
turned ON when the center ring pin is lowered by 1.5
below)
2) Carefully handle the cables.
40092576
T-PIN sensor assembly
Maintenance Guide
SL6030692TN
SEMS cap bolt with washer
M3×6
Figure 5-10-1 T-PIN Sensor
5-22
0
mm. (Dimension A in the Figure
-0.5
Ｔ・ＰＩＮセンサ
T-PIN sensor
Rev. 2.0
調整ねじ
Adjustment screw
センサブラケット
Sensor bracket