Replacing The Belts; Replacing The Timing Belt Z; Replacing The Timing Belt Θ - JUKI KE-3010 Maintenance Manual

2-6. Replacing the Belts

2-6-1. Replacing the Timing Belt Z

After the timing belt Z has been replaced, it is absolutely necessary to re-input the MS
parameters related to the Z-axis home position adjustment, Z-axis height, and laser. (For details
of input items, see section 2-8.)
1) Loosen the SEMS cap bolts
shown in the figure on the right.
2) Replace the timing belt Z.
3) Reassemble the components in the
reverse order of disassembly.
∗ Apply Loctite 242 to the Z-motor mounting screws
(3 pcs.) and tighten them with a tightening torque of
2.3 N⋅m.
∗ Adjust the belt tension following section 2-2-1.
2-6-2. Replacing the Timing Belt θ
After the timing belt θ has been replaced, it is absolutely necessary to re-input the MS parameters
related to the Z-axis home. (For details of input items, see section 2-8.)
1) Detach the bearing base
2) Detach the ball spline from the coupling
3) Pull out the spline housing downward and the spline
shaft upward.
4) Replace the timing belt θ.
5) Reassemble the components in the reverse
order of disassembly.
∗ When the bearing base L is secured, make
sure that the shaft is rotated smoothly.
∗ Adjust the belt tension following section
2-2-2.
Maintenance Guide
SL6031692TN
(×3)
SEMS cap bolt with
washer M3×16
40046522
Timing belt Z
.
.
L1 to L3: Bearing base LL
L4 to L6: Bearing base LR
2-17
Figure 2-6-1-1 Removing the
40046521
Timing Belt T
Timing Belt θ
Ball spline
Coupling
Figure 2-6-2-1 Replacing the
Rev. 2.0
Z-motor
Timing Belt θ