JUKI KE-3010 Maintenance Manual page 281

8) The screen will appear that allows you to select the mechanism control parameter
initialization and existing software backup.
∗ CAUTION
<Mechanism control parameter initialization> (Do you renew Mech Control Parameter?)
Yes Mechanical control parameters are initialized and the default values are set.
Currently set mechanical control parameters are succeeded to a new version.
No
When upgrading the program, newly required data becomes the default values.
<Existing software backup> (Is the existing soft backup performed?)
Check on [Yes] or [No] in each area to start the installation.
Appendix:
Maintenance Guide
The button displays may vary depending
on the language specification of the OS.
Yes The exiting software is backed up.
No The backup process of the exiting software is skipped.
About mechanical control parameters
The mechanical control parameters are an aggregate of
threshold value data.
The following shows the major setting data
Speed data for head operation
Speed data for X/Y-axis operation
Speed data for support table operation
R.P.M. of AWC/Center motor
Time data for ATC control
13-36
Rev. 2.0
to .