22-5-2. EPV Calibration
Follow the steps below to obtain the placement monitor calibration value.
[Outline]
Capture the mark on the jig board using the EPV camera ("+" at the lower left portion of the board)
to obtain the offset value.
Open the "Program Editor" screen and load the jig board.
Teach the coordinates of the "+" mark using the OCC of the mark HOD.
Using the head selection of the HOD, select 'L1' and move the L1 head to the mark
coordinate position.
Maintenance Guide
"Board mark (+)"
JUKI demonstration board (165 × 125 mm)
Teach coordinates
22-9
(P/N 1CD7501D-01, etc.)
Load board
Rev. 2.0