Table of Contents
Advertisement
4)
Run the ZTD-CN5 cable through the route indicated by a blue arrow mark shown in the
Figure 1-6-7-1 and insert it into the location shown in the Figure 1-6-7-3.
5)
Run the FMLA cable through the same route as the ZTD-CN5 and the route indicated by a
blue arrow mark shown in the Figure 1-6-7-3. Insert the cable into the location shown in the
Figure 1-6-7-4.
Figure 1-6-7-3 (Figure above shows the case of XL board specifications.)
FMLA
6)
Run the 1394 ROBOT CABLE through the route shown in the Figure 1-6-7-5 and relay it at
the location shown in the Figure 1-6-7-6.
The cable is relayed on the rear of the connector enclosed by a red circle.
Maintenance Guide
Figure 1-6-7-4
1-49
Rev. 2.0
ZTD-CN5
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
