Drive Control Via Profinet Or Profibus; Receive Data And Send Data; Cyclic Data Exchange; Parameters For The Scaling Characteristic - Siemens SINAMICS G120X Operating Instructions Manual

Advanced commissioning
6.3 Drive control
Parameters
Table 6-7
Parameter
p0777[0...1]
p0778[0...1]
p0779[0...1]
p0780[0...1]
6.3.3

Drive control via PROFINET or PROFIBUS

6.3.3.1

Setting the address

Function description
Procedure
1. Set the address with a commissioning tool via p0918
2. Switch off the converter power supply.
3. Wait until all LEDs on the converter are dark.
4. Switch on the converter power supply again.
Your settings become effective after switching on.
The PROFIBUS address is set.
❒
6.3.3.2

Receive data and send data

Overview

Cyclic data exchange

The converter receives cyclic data from the higher-level control - and returns cyclic data to the
control.
Figure 6-10
206

Parameters for the scaling characteristic

Description
CU analog outputs characteristic value x1
CU analog outputs characteristic value y1
CU analog outputs characteristic value x2
CU analog outputs characteristic value y2
Cyclic data exchange
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
Factory setting
-
0 V
100%
20 V
SINAMICS G120X converter