Table of Contents
Advertisement
NOTICE
An ASCII table (excerpt) can be found, for example, in the Appendix of the List Manual.
When using the STARTER commissioning tool, the password should be entered via the associated dialogs.
The following rules apply when entering the password:
- password entry must start with p7766[0].
- no gaps are permissible in the password.
- entering a password is completed when writing to p7766[29] (p7766[29] = 0 for passwords less than 30 characters).
Note
KHP: Know-How Protection
When reading, p7766[0...29] = 42 dec (ASCII character = "*") is displayed.
Parameters with the "KHP_WRITE_NO_LOCK" attribute are not involved in the know-how protection.
Parameters with the "KHP_ACTIVE_READ" attribute can be read even when know-how protection is activated.
A product-specific list of these parameters is also available in the corresponding List Manual.
p7767[0...29]
KHP password new / KHP passw new
Access level: 3
Can be changed: T, U
Unit group: -
Min:
-
Description:
Sets the new password for know-how protection.
Dependency:
See also: p7766, p7768
Note
KHP: Know-How Protection
When reading, p7767[0...29] = 42 dec (ASCII character = "*") is displayed.
p7768[0...29]
KHP password confirmation / KHP passw confirm
Access level: 3
Can be changed: T, U
Unit group: -
Min:
-
Description:
Confirms the new password for know-how protection.
Dependency:
See also: p7766, p7767
Note
KHP: Know-How Protection
When reading, p7768[0...29] = 42 dec (ASCII character = "*") is displayed.
p7769[0...20]
KHP memory card reference serial number / KHP mem ref ser_no
Access level: 3
Can be changed: T
Unit group: -
Min:
-
Description:
Sets the reference serial number for the memory card.
Using this parameter, if a Control Unit and/or a memory card is replaced at the end customer, the OEM can again adapt
the project to the modified hardware.
Dependency:
See also: p7765, p7766, p7767, p7768
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Parameters
7.2 Parameter list
Data type: Unsigned16
Dynamic index: -
Function diagram: -
Factory setting:
-
Data type: Unsigned16
Dynamic index: -
Function diagram: -
Factory setting:
-
Data type: Unsigned8
Dynamic index: -
Function diagram: -
Factory setting:
-
863
Advertisement
Table of Contents
