Table of Contents
Advertisement
Mounting
NOTICE
Device damage due to installation with power supply switched on
Installing or removing the SINAMICS G120X I/O Extension Module when the converter is in
the power-on state can cause damage to the device.
● Make sure that the converter is powered off before installing or removing the SINAMICS
To mount the I/O Extension Module, you must first open the cover of X21 interface (Page 99)
at the front of the Control Unit of the converter, and then proceed with the following steps:
1.
2.
3.
You have now mounted the I/O Extension Module.
❒
Note
The SINAMICS G120X I/O Extension Module does not support the mounting in the door of a
control cabinet.
Wiring the terminal strips
For more information on wiring the terminal strips, refer to the following chapters:
2.6.12
Operator panel
An operator panel can be ordered either together with the converter or separately as an optional
component. It has been designed to enhance the interface and communications capabilities of
the converter. You can use an operator panel to commission, troubleshoot, and control the
converter, as well as to back up and transfer the converter settings.
The operator panels (BOP-2 and IOP-2) can be mounted either directly on the converter or in
a control cabinet door using a door mounting kit.
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
G120X I/O Extension Module.
Locate the lower edge of the I/O Ex‐
tension Module into the matching re‐
cess of the Control Unit.
Plug the module onto the converter
until the latch audibly engages.
Open the cover of the terminal strips
at the front of the I/O Extension Mod‐
ule, and fix the module with the pro‐
vided M3 screw.
Terminal strips (Page 101)
Wiring the terminal strips (Page 139)
Description
2.6 Optional components
47
Advertisement
Table of Contents
