Table of Contents
Advertisement
p3985
Master control mode selection / PcCtrl mode select
Access level: 3
Can be changed: T, U
Unit group: -
Min:
0
Description:
Sets the mode to change over the master control / LOCAL mode.
Value:
0:
1:
DANGER
When changing the master control in operation, the drive can manifest undesirable behavior - e.g. it can accelerate
up to another setpoint.
r3986
Number of parameters / Param count
Access level: 3
Can be changed: -
Unit group: -
Min:
-
Description:
Displays the number of parameters for this drive unit.
The number comprises the device-specific and the drive-specific parameters.
Dependency:
See also: r0980, r0981, r0989
r3988[0...1]
Boot state / Boot_state
Access level: 4
Can be changed: -
Unit group: -
Min:
0
Description:
Index 0:
Displays the boot state.
Index 1:
Displays the partial boot state
Value:
0:
1:
10:
20:
30:
40:
50:
90:
100:
101:
110:
111:
112:
113:
114:
115:
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
Change master control for STW1.0 = 0
Change master control in operation
Not active
Fatal fault
Fault
Reset all parameters
Drive object modified
Download using commissioning software
Parameter download using commissioning software
Reset Control Unit
Start initialization
Only for internal Siemens use
Instantiate Control Unit basis
Only for internal Siemens use
Only for internal Siemens use
Only for internal Siemens use
Only for internal Siemens use
Parameter download using commissioning software
Calculated: -
Scaling: -
Unit selection: -
Max:
1
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: -
Unit selection: -
Max:
800
Parameters
7.2 Parameter list
Data type: Integer16
Dynamic index: -
Function diagram: -
Factory setting:
0
Data type: Unsigned16
Dynamic index: -
Function diagram: -
Factory setting:
-
Data type: Integer16
Dynamic index: -
Function diagram: -
Factory setting:
-
851
Advertisement
Table of Contents
