Manage The Device With Cdo; Access The Ftd And Fxos Cli - Cisco Firepower 1010 Getting Started Manual

Firepower Threat Defense Deployment with CDO

Manage the Device with CDO

After having onboarded the device to CDO, you can manage the device with CDO. To manage the FTD with
CDO:
1. Browse to https://sign-on.security.cisco.com.
2. Log in as the user you created in
3. Review
What to do Next
You have now configured an FTD device and onboarded it to CDO, which provides a simplified management
interface and cloud-access to your FTD devices. Use CDO to upgrade software, configure high availability,
and configure device settings and network resources for your FTD devices.

Access the FTD and FXOS CLI

Use the command-line interface (CLI) to set up the system and do basic system troubleshooting. You cannot
configure policies through a CLI session. You can access the CLI by connecting to the console port.
You can also access the FXOS CLI for troubleshooting purposes.
Note
You can alternatively SSH to the Management interface of the FTD device. Unlike a console session, the SSH
session defaults to the FTD CLI, from which you can connect to the FXOS CLI using the connect fxos
command. You can later connect to the address on a data interface if you open the interface for SSH connections.
SSH access to data interfaces is disabled by default. This procedure describes console port access, which
defaults to the FXOS CLI.
Procedure
Step 1 To log into the CLI, connect your management computer to the console port. The Firepower 1000 ships with
a USB A-to-B serial cable. Be sure to install any necessary USB serial drivers for your operating system (see
the Firepower 1010
settings:
• 9600 baud
• 8 data bits
• No parity
• 1 stop bit
You connect to the FXOS CLI. Log in to the CLI using the admin username and the password you set at
initial setup (the default is Admin123).
Create a New Cisco Secure Sign-On Account, on page
Managing FTD with Cisco Defense Orchestrator
hardware guide). The console port defaults to the FXOS CLI. Use the following serial
Manage the Device with CDO
for links to common management tasks.
Cisco Firepower 1010 Getting Started Guide
37.
55