Mpls Ldp Hello-Interval - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

10-11 mpls ldp hello-interval

mpls ldp hello- interval SECONDS
no mpls ldp hello- interval
Syntax Description
SECONDS
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface vlan 10
Switch(config-if)# mpls ldp hello-interval 10
CLI Reference Guide
Use the mpls ldp hello- interval command to configure the LDP link hello
interval time for the interface. Use the no form of this command to restore the
default value.
Specifies the link hello interval time in seconds. The range is 1-65535 seconds
5 seconds.
Interface configuration.
This command only can be applied on a Layer 3 VLAN interface.
Use the mpls ldp hello- interval command to configure the LDP link hello
interval time for the interface. LDP sends link hello message according the hello
interval period.
The hello interval time on the interface shall less than its hello hold-time. It's
recommend to set the hello interval less than one third of the hello hold-time.
The user can verify their settings by entering the show mpls ldp interface
command.
This example shows how to configure the hello interval time of VLAN 10 interface
to 10 seconds :
mpls ldp hello-interval
277