Table of Contents
Advertisement
4 Configuration
The fields that can be configured are described below:
Item
D-Link
discovery
Protocol State
Report Timer
Click Apply to make the configurations take effect.
L2 Features > FDB > Static FDB > Unicast Static FDB
The Unicast Static FDB window allows user to view and configure the static unicast forwarding settings on
the Switch.
The fields that can be configured are described below:
Item
Port / Drop
Port Number
VID
MAC Address
Click Apply to make the configurations take effect.
Click Delete All to delete all the entries found in the display table.
Click Delete to remove the corresponding entry.
L2 Features > FDB > Static FDB > Multicast Static FDB
This window allows user to view and configure the static multicast forwarding settings on the Switch.
Figure 4.26 - Management > D-Link Discovery Protocol
Description
Specify to enable or disable the D-Link discovery protocol feature of
the Switch.
Configure the report timer of the D-Link Discover Protocol in
seconds. The values are 30, 60, 90, 120 or Never. The default is
Never.
Table 4.11
Figure 4. 27 - Features > FDB > Static FDB > Unicast Static FDB
Description
The selection of the port number on which the MAC address
entered resides. This option could also drop the MAC address from
the unicast static FDB. When selecting Port, select the switch port
number.
Select the port number used here, when Port is selected in the
previous drop-down list.
Enter the VLAN ID of the VLAN which the corresponding MAC
address belongs to.
Enter the MAC address to which packets will be statically forwarded
or dropped. This must be a unicast MAC address.
Table 4.12
D-Link Smart Managed Switch User Manual
2
2
1
1
Advertisement
Table of Contents
