Chrysler Conquest 1988 Service Manual page 219

BRAKES - Parking Brake Cable
5-69
5. REMOVAL OF COTTER PIN / 6. WASHER / 7. CLEVIS
PIN / 8. CLIP
(1) Remove the cotter pin, clevis pin and washer.
(2) Remove the clip by pulling downward, and remove the
parking brake cable out of the groove in the brake body.
9. REMOVAL OF PARKING BRAKE CABLE
(1) Remove the parking brake cable mounting bracket from
the lower control arm.
(2) Pull the parking brake cable out of the vehicle.
INSPECTION
NOBXCAB
Check the parking brake cable for damage and operation.
SERVICE POINTS OF INSTALLATION SERVICE POINTS OF INSTALLATION
NOlXDAB NOlXDAB
9. APPLICATION OF SEALANT TO PARKING BRAKE 9. APPLICATION OF SEALANT TO PARKING BRAKE
CABLE CABLE
Apply drying sealant to the grommet and body panel Apply drying sealant to the grommet and body panel
contact surface. contact surface.
Y14512
. ADJUSTMENT OF PARKING BRAKE LEVER STROKE
Adjust the adjuster to make sure that the-number of clicks
is within specification when the lever is pulled with 200 N
(45 Ibs.) force. (Refer to P.5-33.)
Standard value: 4 - 5 clicks
1. INSTALLATION OF REAR FLOOR CONSOLE
Refer to GROUP 23 BODY - Floor Console.