Chrysler Conquest 1988 Service Manual page 225

CLUTCH
- Service Adiustment Pr.ocedures
6-5
Pedal height Clevis pin play
08YO4:
Clutch switch
Lock nut
08Y62C
-
-
08YO43
SERVICE ADJUSTMENT PROCEDURES
NOGFAAF
CLUTCH PEDAL INSPECTION AND ADJUSTMENT
1. Measure
the clutch pedal height and clutch pedal clevis pin
play. If the clutch pedal height and clutch pedal clevis pin
play are not within the standard value, adjust it by using the
following procedure:
Standard value:
(A) 187 - 193 mm (7.4 - 7.6 in.)
(W 1 - 3 mm (.04 - .I2 in.)
2. Disconnect the clutch switch connector and turn the switch
for standard clutch pedal height, Then lock with the lock
nut.
3. Turn the push rod so as to adjust so that the play at clutch
pedal clevis pin becomes within the standard value, and
then secure with the lock nut.
Caution
Do not push the push rod in when making the
adjustment of clutch pedal clevis pin play.
4. After depressing the clutch pedal a few times, confirm that
the distance between the clutch pedal and the floorboard is
more than the standard value when the clutch is disen-
gaged.
Standard value (C): 35 mm (1.4 in.)
5. Then, measure the clutch pedal free play (including the play
at the clutch pedal clevis pin) and confirm that it is within
the standard value.
Standard value (D): 6 - 13 mm (.2 - .5 in.)
If the clearance and/or the clutch pedal free play do not
meet the standard value, probably there is air in the
hydraulic system or a malfunction of the clutch itself, so
bleed out the air or disassemble and inspect the clutch.