Chrysler Conquest 1988 Service Manual page 228

CLUTCH
- Clutch Pedal
nm
OSY62:
I I
YO851!
r, Brake pedal
Washer
Cl&s pin
1411004~
INSPECTION
CLUTCH SWITCH
NOWCAE
Check the clutch switch operation as follows:
Check with a circuit tester -connected to the clutch switch l
terminal. The switch is normal if there is continuity when the ~_
switch plunger ispushed jn and no continuity when the plunger
is released. t:~ ~~
e Check the bushing for wear.
0 Check the pedal arm for bend or torsion.
l
Check the return spring for damage.
=
SERVICE POINTS OF INSTALLATION
NO6PDAH
9. APPLICATION OF GREASE TO SPACER / 8. PEDAL
SHAFT BUSHING / 7. PEDAL SHAFT
Apply specifiid grease ta;the spacer, pedal shaft bushing _
and pedal shaft.
Specified grease: MOPAR Multi-Mileage Lubricant Part -
No. 2525035 or equivalent
6. APPLICATION OF GREASE TO CLEVIS PIN
Apply specified grease to the clevis pin.
Specified grease: MOPAR Multi-Mileage Lubricant Part
No. 2525035 or equivalent
3.
-
APPLICATION OF GREASE TO RETURN SPRING
Apply specified grease to the return spring.
Specified grease: MOPAR Multi-Mileage Lubricant Part
No. 2525035 or equivalent
NOTE
When installing the returnspring, install the pedal side first 4
and then depress the pedal and install the pedal support
side.
-