Chrysler Conquest 1988 Service Manual page 200

BRAKES
- Front Disc Brakes
12. REMOVAL OF PISTON
Remove the piston by applying compressed air through the z
brake hose fitting hole.
Caution
Place a piece of cloth in front of the piston, and slowly
increase the force of the compressed air to prevent the
piston from springing out abruptly.
14Y7% I
13. REMOVAL OF PISTON SEAL
Remove the ~piston seal.
Caution
Be careful not to damage the caliper bore.
INSPECTION
NO5LGCA
CALIPER ASSEMBLY
@ Check the caliper suppon for cracks.
l
Check the caliper body for cracks and cylinder for rust,
@ Check the piston for rust.
Caution
The bushing, pin boot, cap, dust boot and piston seal must
all be replaced with ne&~ parts.
SERVICE POINTS OF REASSEMBLY
13. APPLICATION OF GREASE TO PISTON
NOBLHCA
(1)
(2)
(3)
Apply the-~specified brake fluid to the
Specified brake fluid: MOPAR Brake
SEAL
m--z:
cylinder walls. E
Fluid Part No.
_-
ZK
2933249 or equivalent
m-
--:e
-
Fit a new piston seal into the cylinder.
NOTE --
The piston seal in the-repair kit is coated with special r
grease. Be careful noito wipe off this grease. 7- E
Apply the~specified grease to the lip of the cylinder.
Specified grease: Repair kit grease (pink)