Chrysler Conquest 1988 Service Manual page 210

5-60
-~ ---if&G
- --;
Es-
=&
-pi
BRAKES
- Rear Brake Lock-up Control System
c-=
G=-
EL"
E=e-
G-SENSOR
c=.
-.
Voltage characteristic of G-sensor
0
Lav the G-sensor down SIOWIY so
that the mark faces upward.
Measure the voltage of the G-sensor when it is laid down in I z
accordance with the following procedure.
(1) Check voltage across R wire of G-sensor and ground for 7.0 i
to -7.5 V:Voltage other than 7.0 to 7.5 V indicates faulty '
z
control unit.
~1
-
_-
-- w I".
E!!r-
(2) Remove G-sensor and ground to vehicle body by wire.
(3) Measure voltage across G wire of G-sensor and ground. 7
Standard value: 1 .I - 1.5 V
(4) Turn G-sensorwith mark upward. Measure voltage across I
G wire of G-sensor and ground. ~~~
Standard value: 4.6 - 5.0 V
If the voltage-is out of standard value, replace the G-sensor, 1
REAR BRAKE LOCK-UP CONTROL RELAY
(1) Remove the rear brake lock-up control relay.