Chrysler Conquest 1988 Service Manual page 192

5-42
BRAKES
- Brake Master Cylinder
I
Primary piston
Secondary piston
14Y77!
14UOOE
I
Y146191
CLEARANCE BETWEEN MASTER CYLINDER INNER DIA-
METER AND PISTON OUTER DIAMETER
(1) Measure approximately three positions of the. master
cylinder inner diameter [bottom (A), middle (B)
and top (C)l
by using a cylinder gauge:
(2) Measure O.DI of pistonsat illustrated
location
using~ a ~~_
micrometer.
-
NOTE
Measure the inner diameter of master cylinder at the two :
places described above and at D and E,shown In the z
illustration. ~~~
.-
(3) If the difference between-these-inner diameters and the, ~
piston outer diameter exceeds the limit, replace the master _;
cylinder and the piston assembly as set.
Limit: 0.15 mm (.006 in.)
SERVICE POINTS OF REASSEMBLY
NOBHCAH
21. APPLICATION OF BRAKE FLUID TO RESERVOIR CAP
DIAPHRAGM SURFACE
Apply specified brake fluid to the diaphragm surface of the mzI
reservoir cap and tighten the cap, taking care not to distort _
the diaphragm.
Specified brake fluid: MOPAR Brake Fluid Part No.
2933249 or equivalent
15. APPLICATION OF BRAKE MASTER CYLINDER BODY TO
BRAKE FLUID / 14. SECONDARY PISTON / 13. PRIM-
ARY PISTON
Apply the specified brake fluid ~sufficiently to the inner
surface of
the
master cylinder body and to the entire
periphery of the secondary and primary pistons.
Specified brake fluid: MOPAR Brake Fluid Part No.
2933249 or equivalent