Chrysler Conquest 1988 Service Manual page 215

BRAKES
- Rear Brake Lock-up Control System
5-65
piston)
I
\ Check valve
14Y290
14Y30E
14Y306
-, Seal cup
Dust seal 1
Snap ring
14Y307
12. INSTALLATION OF CHECK VALVE SEAL
After coating the check valve seal with specified brake fluid,
install with its larger inner diameter end towards outside.
Specified brake fluid: MOPAR Brake Fluid Part No.
2933249 or equivalent
Caution
If the check valve seal is installed in the reverse
direction, the brake will become inoperative.
9. APPLICATION OF FLUID TO O-RING
Coat O-ring with specified brake fluid and install it to the
bleeder cap.
Specified brake fluid: MOPAR Brake Fluid Part No.
2933249 or equivalent
7. APPLICATION OF FLUID TO SEAL CUP
Coat the seal cup with rust preventive agent and install it
with its concave side directed towards the hydraulic
cylinder.
Specified brake fluid: MOPAR Brake Fluid Part No.
2933249 or equivalent
5. INSTALLATION OF CUP RETAINER
Install the cup retainer, with its large outer diameter end on
the hydraulic cylinder side.
4. INSTALLATION OF SNAP RING
Fit the snap ring securely in the snap ring groove.
NOTE
After installation of the snap ring, hold the cup retainer
lightly with a long-nosed pliers'and pull it to make sure that
the snap ring is positively installed.
3. INSTALLATION OF DUST SEAL
(1) Apply the specified grease to the dust seal.
Specified grease: Repair kit grease (silicone grease)
(2) While holding it with fingers, install it to each of the cup
retainer and hydraulic cylinder.
Caution
Do not force the periphery of the dust seal inward,
because a specified clearance is provided between
dust seal and snap ring.