Chrysler Conquest 1988 Service Manual page 214

~ L/,-
_____
5-64
BRAKES
- Rear Brake Lock-up Control System
Bushing
17. REMOVAL OF BUSHING / 18. CHOKE VALVE PISTON
/ I
r
(1) Hold the end of choke~valve piston with a long-nosed
I
pliers or the like and remove the choke valve piston and
~
bushing at-the same time from the hydraulic cylinder.
(2) Push the choke valve ptiton out with fingers to remove 11
it from the bushing.
' Choke valve piston
n
Trim stick
Choke valve piston
Valve
cap
14y30:
.-
19. REMOVAL OF O-RING
Remove 0rrng from the choke valve piston with the trim
-I
stick.
INSPECTION
N050GAA
l
Check the each valve spring for weakness.
0 Check the hydraulic cylinder tor rust and scars on lnslde .-f
surface.
* Check the check valve piston and choke valve prston for
_
rust, scars, wear and weakness.
SERVICE POINTS OF REASSEMBLY
N050HAD
19. INSTALLATION OF O-RING / 18. CHOKE VALVE PISTON
/ 17. BUSHING
(1) Coat O-ring with specifEd brake fluid
and
install it to the __
choke valve piston.
Specified brake fluid: MOPAR Brake Fluid Part No.
2933249 or equivalent
(2) AssembMhe choke valve piston to the bushing before
-;
installing it to the hydraulic cylinder.
13. INSTALLATION OF VALVE CAP
After tightening the valvezap, clearance (A) of 0.5 to 1.0 ~~-I1
mm (.02 to .04 in.) mustie left.
.=