Chrysler Conquest 1988 Service Manual page 194

14u0050
14Y62f 3
Brake bQQSter
side-
Engine side
14E517
INSPECTION
NOSJCAD
Check the check- valve operation as follows.
l
Blow into the-check valves If the air passes through when
I
you blow from the booster side, but not when you blow -
from the. engine side, the check valve his functioning 1:
properly.
SERVICE POINTS OF INSTALLATION
N05JDAK
10. APPLICATION OF GREASE TO WASHER / 9. CLEVIS PIN
Apply specified grease to devis pin and wash_er. Then insert _*
clevis pin an'd bend the 7zotter pin tightly.
Specified grease: MOPAR Multi-mileage Lubricant Part
No. 2525035 or equivalent
7. APPLICATION OF SEALANT TO FITTING
When installing the fitting,apply the semi-drying sealant to --
its threaded portion.
5. INSTALLATION OF CHECK VALVE
Install the check valve, noting the direction of installation. -;
4. INSTALLATION OF VACUUM HOSE
Fasten the v!uum hose securely to prevent air leaks from
the connections.
--
Insert the vacuum hosexntil~ it is seated on the fitting s-i
flange.
3. INSTALLATION OF BRAKE MASTER CYilNDkR
Check the booster push rod to brake master cylinder piston
clearance. zr
Standard value: 0.7 - 1.1 mm (-028 - .043 in.)