OVERVIEW
Category:
Primary context:
Related Commands
Usage: boot [system [flash <primary|secondary>] [config FILENAME]]
boot set-default flash <primary|secondary>
boot active
boot standby
Description: Reboot the device. The primary or secondary software image
Parameters:
o set-default- Sets the default flash boot image for next boot.
o active
o standby
NOTES
Italicized "config" Keywords
The italicized "config | config1" keywords correspond to the names selected for the config
files.
COMMAND STRUCTURE
■ boot
active
■ boot
set-default
flash
< primary | secondary > -- Specify the default flash boot image.
■
■ boot
standby
■ boot
system
flash
< primary | secondary > -- Specify boot image to use after reboot.
■
config
■
COMMAND DETAILS
active (p. 73)
config (p. 74)
active
■ boot active
Note: This command applies to the 8212zl switch only.
Reboot the active management module. The switch starts to boot from the
default flash image. You can select which image to boot from during the
boot process itself. The switch will switchover to the standby management
© 2009 Hewlett-Packard Development Company, L.P.
Switch Management
manager
reload (page 467)
can be specified to be used during the boot process.
Optionally, a configuration file can be set for this boot.
- Causes switchover and reboots the
module, if redundancy is enabled and the other module
is present. Reboots the system if redundancy is disabled
or the module is not present.
- Reboots the standby management module.
-- Reboot the active management module.
-- Specify the default flash boot image.
-- Reboot the standby management module.
-- Allows user to specify boot image to use after reboot.
< config | config1 > -- Specify configuration file to use on boot.
flash (p. 74)
set-default (p. 74)
active management
(p. 73)
(p. 74)
(p. 74)
(p. 74)
(p. 75)
(p. 74)
(p. 74)
standby (p. 74)
system (p. 75)
boot
73