Command Line Interface Reference Guide
■ interface vlan VLAN-ID ip ospf all retransmit-interval < 1 to 3600 >
Set retransmit interval in seconds; the default is 5.
Range: < 1 to 3600 >
rip
■ [no] interface vlan VLAN-ID ip rip
Usage: [no] ip rip [...]
Description: Enable/disable/configure Routing Internet Protocol (RIP)
Next Available Options:
authentication-type
■
authentication-key
■
metric
< 1 to 15 > -- Set metric for this
■
poison-reverse
■
receive
< V1-only | V2-only | V1-or-V2 | ... > -- Define RIP version for incoming
■
send
< disabled | V1-only | V1-compatible-V2 | ... > -- Define RIP version for outgoing
■
275)
rip-compatible
■
packets.(p. 274)
ip-addr
-- Specify the IP address the request is for. (IP-ADDR)
■
all
-- Process the request for all IP
■
rip-compatible
■ interface vlan VLAN-ID ip rip < V1-only | V2-only | V1-or-V2 >
Define RIP version for incoming and outgoing packets.
Supported Values:
■ V1-only -- Use RIP version 1 only.
■ V2-only -- Use RIP version 2 only.
■ V1-or-V2 -- Use RIP 2 in the RIP 1 compatible mode.
■ interface vlan VLAN-ID ip rip IP-ADDR < V1-only | V2-only | V1-or-V2 >
Define RIP version for incoming and outgoing packets.
Supported Values:
■ V1-only -- Use RIP version 1 only.
■ V2-only -- Use RIP version 2 only.
■ V1-or-V2 -- Use RIP 2 in the RIP 1 compatible mode.
■ interface vlan VLAN-ID ip rip all < V1-only | V2-only | V1-or-V2 >
Define RIP version for incoming and outgoing packets.
© 2009 Hewlett-Packard Development Company, L.P.
on the VLAN interface.
Called without 'no', the command enables RIP on the interface.
Otherwise ('no' is specified), the command disables RIP on the
interface. The command can be followed by a RIP configuration
command. Use 'ip rip ?' to get a list of all possible options.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
< none | text > -- Set authentication type used on this
-- Set RIP authentication key (maximum 16
-- Enable/disable poison reverse on this
< V1-only | V2-only | V1-or-V2 > -- Define RIP version for incoming and outgoing
interface.(p. 250)
interface.(p. 262)
addresses.(p. 219)
interface.(p. 224)
characters).(p. 223)
packets.(p. 273)
packets.(p.
(p. 241)
interface
274