HP ProCurve 5400zl Reference Manual page 59

Command Line Interface Reference Guide
Next Available Options:
web-list1
■
([ethernet] PORT-LIST)
dhcp-addr
■
default is 192.168.0.0, mask default is 24 - 255.255.255.0). (IP-ADDR/MASK-LENGTH)
dhcp-lease
■
(NUMBER)
ewa-server
■
(p. 34)
web-list1
■ [no] aaa port-access web-based [ETHERNET] PORT-LIST
Manage web authentication based network authentication on the device port(s).
Next Available Options:
client-limit
■
(NUMBER)
client-moves
■
31)
ssl-login
■
redirect-url
■
none), Specify url up to 103 characters
max-retries
■
authentication is considered to have failed (default 3). (NUMBER)
logoff-period
■
an implicit logoff (default 300 seconds). (NUMBER)
quiet-period
■
(default 60 seconds). (NUMBER)
server-timeout
■
seconds). (NUMBER)
© 2009 Hewlett-Packard Development Company, L.P.
the switch considers an implicit logoff (default 300)
o 'reauth-period' sets the period of time after which connected
clients must be re-authenticated.
to 0 the re-authentication is disabled (default 0).
o 'auth-vid' configures the VLAN to which to move a port
after successful authentication.
override the value.
this PVID to 0.
occur unless RADIUS server requests.
immediately. All clients must immediately re-authenticate.
The default is 0.
o 'unauth-vid' configures the VLAN to which to move a port
after failed authentication.
to set this PVID to 0.
The default is 0.
o 'reauthenticate' forces re-authentication
of all clients present on a port.
-- Manage web authentication based network authentication on the device port(s).
(p. 57)
-- Set the base address / mask for the temporary pool used by DHCP (base address
< 5 to 25 > -- Set the lease length of the IP address issued by DHCP (default 10).
(p. 33)
-- IP address or hostname of the enhanced web authentication server on the device.
< 1 to 32 > -- Set the port's maximum number of authenticated clients (default 1).
(p. 31)
-- Set whether the client can move between ports (default disabled - no
-- Set whether to enable SSL login (https on port 443) (default
-- Set the URL that the user should be redirected to after successful login (default
< 1 to 10 > -- Set number of times a client can enter their credentials before
< 1 to 9999999 > -- Set the period of time of inactivity that the switch considers
< 1 to 65535 > -- Set the period of time the switch does not try to authenticate
< 1 to 300 > -- Set the authentication server response timeout (default 30
(p. 50)
When the timeout is set
RADIUS server can
Use 'no' form of the command to set
If the PVID is set to 0 no PVID changes
Use 'no' form of the command
Changes take effect immediately.
length.(p. 48)
(p. 36)
(p. 47)
Changes take effect
disabled).(p. 50)
(p. 39)
aaa
(p. 33)
moves).(p.
57