HP ProCurve 5400zl Reference Manual page 628

Command Line Interface Reference Guide
Set authentication protocol.
Supported Values:
■ MD5 -- Set the authentication protocol to md5.
■ SHA -- Set the authentication protocol to sha.
Next Available Option:
authpassword
■
community
■ [no] snmpv3 community
Configure SNMPv3 Community entry.
Next Available Option:
index -- Set community index. (ASCII-STR)
■
enable
■ [no] snmpv3 enable
Enable SNMPv3.
engineid
■ [no] snmpv3 engineid ENGINEID
Configure SNMPv3 engineID.
filter
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IP-ADDR filter < None | Debug | All
| ... >
Set log filters.
Supported Values:
■ None -- Send no log messages.
■ Debug -- Send debug traps (for Internal use).
■ All -- Send all log messages
■ Not-INFO -- Send all but informational-only messages.
■ Critical -- Send critical-level log messages.
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IPV6-ADDR filter < None | Debug |
All | ... >
Set log filters.
Supported Values:
■ None -- Send no log messages.
■ Debug -- Send debug traps (for Internal use).
■ All -- Send all log messages
■ Not-INFO -- Send all but informational-only messages.
■ Critical -- Send critical-level log messages.
© 2009 Hewlett-Packard Development Company, L.P.
-- Set authentication password. (ASCII-STR) (p. 625)
(p. 627)
snmpv3
626