HP ProCurve 5400zl Reference Manual page 63

Command Line Interface Reference Guide
<icmp>
Insert an ACE or a remark by assigning a sequence number:
ProCurve(config)# ipv6 access-list <name-str>
ProCurve(config-ipv6-acl)# <seq-#> <deny|permit|remark>
Note: The deny and permit keywords use the options show above
for "Create and IPv6 ACL".
Delete an ACE or a Remark (or both) by sequence number:
ProCurve(config)# ipv6 access-list <name-str>
ProCurve(config-ipv6-acl)# no <seq-#> [remark]
Note: You can also delete an ACE by entering no <permit|deny>
followed by the settings explicitly configured for that
ACE.
Resequence the ACEs in an ACL:
ProCurve(config)# ipv6 access-list resequence <name-str><starting-#>
Enter a Remark:
ProCurve(config)# ipv6 access-list <name-str>
ProCurve(config-ipv6-acl)# remark <remark-str>
Remove a Remark:
Immediately after entry:
ProCurve(config-ipv6-acl)# no remark
After entry of an ACE:
ProCurve(config-ipv6-acl)# no <seq-#> remark
Delete an IPv6 ACL:
ProCurve(config)# no ipv6 access-list <name-str> vlan
Enable or Disable an IPv6 VACL:
ProCurve(config)# [no] vlan <vid> ipv6 access-group <name-str> vlan
Enable or Disable a Static Port ACL:
ProCurve(config)# [no] interface <port-list|trkx> ipv6 access-group <name-str> in
ProCurve(eth-<port-list|trkx>)# [no] ipv6 access-group <name-str> in
© 2009 Hewlett-Packard Development Company, L.P.
<any|host <DA>|DA/<prefix-length>>
[comparison-operator <value>]
[established]
[ack][fin][rst][syn]
<any|host <SA>|SA/<prefix-length>>
<any|host <DA>|DA/<prefix-length>>
[0-255 [0-255]|icmp-message]
[dscp <precedence|codepoint>]
[log]
<increment>
access-list
61