HP ProCurve 5400zl Reference Manual page 302

Command Line Interface Reference Guide
Usage: [no] ip igmp forcedfastleave [ethernet] PORT-LIST
Description: When enabled, this feature forces IGMP Fast Leaves to occur
forward
■ ip igmp forward [ETHERNET] PORT-LIST
Usage: ip igmp forward [ethernet] PORT-LIST
Description: Instruct the device to forward incoming multicast packets
high-priority-forward
■ [no] ip igmp high-priority-forward
Usage: [no] ip igmp high-priority-forward
Description: Enable/disable the high priority forwarding of traffic for
icmp
■ [no] ip icmp
Usage: [no] ip icmp [...]
Description: Configure ICMP Rate Limiting capacity. Use 'ip icmp ?' to get
Next Available Options:
addrmask
■
burst-normal
■
296)
echo -- Enable/disable echo replies to broadcast echo
■
redirects
■
reply-limit
■
unreachable
■
igmp
■ [no] ip igmp
Usage: [no] ip igmp [...]
Description: Enable/disable/configure IP Multicast Group Protocol (IGMP)
© 2009 Hewlett-Packard Development Company, L.P.
even when the port is cascaded. See 'ip igmp fastleave' for
more information.
FastLeaves to be disabled.
This feature is configured for ports on a per-VLAN basis.
received on the specified ports.
configured on a per-VLAN basis.
subscribed IP Multicast groups. This feature is configured on
a per-VLAN basis.
a list of all possible configurable parameters.
-- Enable/disable address mask
< 0 to 1000000 > -- The maximum number of icmp replies to send per
-- Enable/disable redirect error
-- Enable/disable ICMP reply rate
-- Enable/disable destination unreachable error
feature. This command enables, disables or configures the
IGMP feature for IGMP communication between Multicast
Routers, Multicast Servers, and Multicast Clients connected
to the switch. If not preceded by 'no', the command accepts
a variety of configuration parameters. To get a list of all
The default behavior is for IGMP Forced
This feature is
replies(p. 294)
requests(p. 299)
messages(p. 306)
limiting(p. 306)
messages(p. 312)
ip
second(p.
300