HP ProCurve 5400zl Reference Manual page 264

Command Line Interface Reference Guide
poison-reverse
■ [no] interface vlan VLAN-ID ip rip poison-reverse
Enable/disable poison reverse on this interface.
■ [no] interface vlan VLAN-ID ip rip IP-ADDR poison-reverse
Enable/disable poison reverse on this interface.
■ [no] interface vlan VLAN-ID ip rip all poison-reverse
Enable/disable poison reverse on this interface.
port-list
■ interface [ETHERNET] PORT-LIST
Usage: [no] interface [ethernet] PORT-LIST [...]
Description: Enter the Interface Configuration Level, or execute one
Next Available Options:
ip -- Apply the specified access control list to inbound packets on this INTERFACE
■
broadcast-limit
■
dhcp-snooping
■
disable -- Disable
■
enable -- Enable
■
flow-control
■
gvrp -- Set the GVRP timers on the port (hundredths of a
■
lacp -- Define whether LACP is enabled on the port, and whether it is in active or passive mode
■
when enabled(p. 247)
mdix-mode
■
monitor
■
name -- Set/unset a name for the
■
power-over-ethernet
■
poe-allocate-by
■
poe-value
■
poe-lldp-detect
■
link-partner's capabilities via
qos -- Set port-based
■
speed-duplex
■
276)
type < Trunk | | | ... > --
■
unknown-vlans
■
© 2009 Hewlett-Packard Development Company, L.P.
command for that level. Without optional parameters
specified, the 'interface' command changes the context to
the Interface Configuration Context Level for execution of
configuration changes to the port or ports in the PORT-LIST.
The 'interface [ethernet] PORT-LIST' can be followed by any
command from the Interface Configuration Context Level in the
same command line. In this case the context level is not
changed, but the command is also executed for the port or ports
in the PORT-LIST. Use 'interface [ethernet] PORT-LIST ?'
to get a list of all valid commands.
< 0 to 99 > -- Set a broadcast traffic percentage
-- Configure the port as trusted or
port(s)(p. 231)
port(s)(p. 232)
-- Enable/disable flow control on the
< mdi | mdix | autoMDIX > -- Set port MDI/MDIX mode (default:
-- Define either the port is to be monitored or
-- Enable/Disable per-port power
-- Control manual power over ethernet
-- Maximum PoE allocation specified with a value in
-- Enabling this feature causes the port to allocate power based on the
LLDP(p. 261)
priority(p. 268)
< 10-half | 100-half | 10-full | ... > -- Define mode of operation for the
(p. 280)
< Learn | Block | Disable > -- Configure GVRP on the
untrusted(p. 230)
port(s)(p. 233)
not(p. 252)
port(s)(p. 254)
distribution(p. 263)
allocation(p. 261)
limit(p. 228)
second)(p. 235)
auto).(p. 250)
watts(p. 261)
port(s)(p. 281)
interface
list(p. 240)
port(s)(p.
262