HP ProCurve 5400zl Reference Manual page 749

Command Line Interface Reference Guide
ip-addr -- Specify the IP address the request is for. (IP-ADDR)
■
all -- Process the request for all IP
■
rip-compatible
■ vlan VLAN-ID ip rip < V1-only | V2-only | V1-or-V2 >
Define RIP version for incoming and outgoing packets.
Supported Values:
■ V1-only -- Use RIP version 1 only.
■ V2-only -- Use RIP version 2 only.
■ V1-or-V2 -- Use RIP 2 in the RIP 1 compatible mode.
■ vlan VLAN-ID ip rip IP-ADDR < V1-only | V2-only | V1-or-V2 >
Define RIP version for incoming and outgoing packets.
Supported Values:
■ V1-only -- Use RIP version 1 only.
■ V2-only -- Use RIP version 2 only.
■ V1-or-V2 -- Use RIP 2 in the RIP 1 compatible mode.
■ vlan VLAN-ID ip rip all < V1-only | V2-only | V1-or-V2 >
Define RIP version for incoming and outgoing packets.
Supported Values:
■ V1-only -- Use RIP version 1 only.
■ V2-only -- Use RIP version 2 only.
■ V1-or-V2 -- Use RIP 2 in the RIP 1 compatible mode.
send
■ vlan VLAN-ID ip rip send < disabled | V1-only | V1-compatible-V2 | ... >
Define RIP version for outgoing packets.
Supported Values:
■ disabled -- Do not send RIP updates.
■ V1-only -- Send RIP version 1 updates only.
■ V1-compatible-V2 -- Send RIP 2 updates using RFC 1058 route subsumption.
■ V2-only -- Send RIP version 2 updates only.
■ vlan VLAN-ID ip rip IP-ADDR send < disabled | V1-only | V1-compatible-V2 | ... >
Define RIP version for outgoing packets.
Supported Values:
■ disabled -- Do not send RIP updates.
■ V1-only -- Send RIP version 1 updates only.
■ V1-compatible-V2 -- Send RIP 2 updates using RFC 1058 route subsumption.
■ V2-only -- Send RIP version 2 updates only.
■ vlan VLAN-ID ip rip all send < disabled | V1-only | V1-compatible-V2 | ... >
Define RIP version for outgoing packets.
Supported Values:
■ disabled -- Do not send RIP updates.
© 2009 Hewlett-Packard Development Company, L.P.
addresses.(p. 715)
(p. 729)
vlan
747