HP ProCurve 5400zl Reference Manual page 733

Command Line Interface Reference Guide
■ vlan VLAN-ID vrrp vrid < 1 to 255 > primary-ip-address IP-ADDR
Specify IP address.
ip-recv-mac-address
■ [no] vlan VLAN-ID ip-recv-mac-address
Usage: [no] ip-recv-mac-address <macaddress> interval <1-255>
Description:
To associate L3-Mac-Address for a VLAN.
ip-recv-mac-address <mac-address> interval <1-255>
To associate L3-Mac-Address with a VLAN with default
timeout interval of 60s.
ip-recv-mac-address <mac-address>
To disassociate L3-Mac_address with a VLAN.
Parameters:
<mac-address>
interval
<1-255>
Next Available Option:
mac-address
■
ipv6
■ vlan VLAN-ID ipv6
Usage: [no] ipv6 ...
Description: Configure various IP parameters for the VLAN. The 'ipv6'
Next Available Options:
enable -- Enable IPv6 on an interface and configures an automatically generated link-local
■
addr.(p. 723)
address
■
mld -- Enable/disable/configure IPv6 Multicast Listener Discovery (MLD) feature on a
■
735)
access-group
■
nd -- IPv6 nodes on the same link use Neighbor Discovery to discover each other's presence,
■
link-layer addresses, routers and to maintain reachability information about the paths to active
neighbors(p. 737)
ipv6-addr
■ [no] vlan VLAN-ID ipv6 address IPV6-ADDR
Configure a link-local IPv6 address.
© 2009 Hewlett-Packard Development Company, L.P.
Associates a L3-mac-address with a VLAN.
no ip-recv-mac-address
- The L3-mac-address to be associated with a VLAN.
- Specify L3-Mac-Address timeout interval.
- Timeout interval in seconds <1-255>.
-- The L3-mac-address to be associated with a VLAN. (MAC-ADDR)
command must be followed by a feature-specific keyword.
Use 'ipv6 ?' to get a list of all possible options.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
-- Set IPv6 parameters for communication within an IP
-- Apply a IPV6 ACl on a VLAN (ASCII-STR)
network(p. 713)
(p. 713)
vlan
(p. 733)
VLAN(p.
731