Command Line Interface Reference Guide
irdp
■ [no] interface vlan VLAN-ID ip irdp
Usage: [no] ip irdp [...]
Description: Configure ICMP Router Discovery Protocol (IRDP). This is
Next Available Options:
advert-address
■
advertisements(p. 219)
holdtime
■
interface(p. 237)
maxadvertinterval
■
unsolicited router
minadvertinterval
■
unsolicited router
preference
■
the same
join-timer
■ interface [ETHERNET] PORT-LIST gvrp join-timer < 20 to 75 >
Set join timer value (centiseconds; default 20).
Range: < 20 to 75 >
jumbo
■ [no] interface vlan VLAN-ID jumbo
Usage: [no] jumbo
Description: Labels this VLAN as a Jumbo VLAN, allowing you to pass
■ [no] interface svlan VLAN-ID jumbo
Usage: [no] jumbo
Description: Labels this VLAN as a Jumbo VLAN, allowing you to pass
kbps
■ interface [ETHERNET] PORT-LIST rate-limit icmp kbps < 0 to 10000000 >
© 2009 Hewlett-Packard Development Company, L.P.
a VLAN context command. It can be called directly from the VLAN
context or may follow the 'vlan VLAN-ID' command prefix.
Called without parameters the command enables or disables (if
preceded by 'no') the protocol on the VLAN specified, or
identified by the current VLAN context. Use 'ip irdp ?' to get
a list of all possible configurable parameters.
< multicast | broadcast > -- Specify the destination address to be used for router
< 4 to 9000 > -- Set the lifetime (in seconds) of the router advertisements sent on this
< 4 to 1800 > -- Set the maximum time (in seconds) allowed between sending
advertisements(p. 249)
< 3 to 1800 > -- Set the minimum time (in seconds) allowed between sending
advertisements(p. 250)
-- The preferability of the router as a default router, relative to the other routers on
subnet(p. 264)
packets up to 9220 bytes in size.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
packets up to 9220 bytes in size.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
interface
246