HP ProCurve 5400zl Reference Manual page 109

Command Line Interface Reference Guide
Copy data to specified configuration file.
Next Available Options:
unix -- Change CR/LF to unix
■
pc -- Change CR/LF to PC
■
■ copy config < config1 | config2 | config3 >
Copy named configuration file.
Supported Values:
■ config1
■ config2
■ config3
Next Available Options:
config -- Copy data to specified configuration file. (ASCII-STR)
■
tftp -- Copy data to a TFTP
■
xmodem
■
■ copy config < config1 | config2 | config3 > config CONFIG
Copy data to specified configuration file.
crash-data
■ copy crash-data
Copy the switch crash data file.
Next Available Options:
card -- Enter single slot identifier. (SLOT-ID-RANGE)
■
mm -- Copy from the management
■
tftp -- Copy data to a TFTP
■
xmodem
■
usb -- Copy data to a USB flash
■
crash-log
■ copy crash-log
Copy the switch log file.
Next Available Options:
card -- Enter single slot identifier. (SLOT-ID-RANGE)
■
mm -- Copy from the management
■
tftp -- Copy data to a TFTP
■
xmodem
■
usb -- Copy data to a USB flash
■
cv_flash
■ copy tftp flash IP-ADDR FILENAME < primary | secondary >
© 2009 Hewlett-Packard Development Company, L.P.
style.(p. 131)
style.(p. 120)
server.(p. 124)
-- Use xmodem on the terminal as the data
server.(p. 124)
-- Use xmodem on the terminal as the data
server.(p. 124)
-- Use xmodem on the terminal as the data
destination.(p. 135)
(p. 105)
card.(p. 119)
destination.(p. 135)
drive.(p. 133)
(p. 105)
card.(p. 119)
destination.(p. 135)
drive.(p. 133)
(p. 106)
copy
107