HP ProCurve 5400zl Reference Manual page 490

Command Line Interface Reference Guide
Parameters:
o source-ip-vlan <VLAN-ID> - The VLAN which IP address will be advertised
o group-prefix <GROUP-ADDR/GROUP-MASK> - The address and mask that specify
o hold-time <3-255> - The hold time value (in seconds) to be send to the
o priority <0-255> - The priority for the Candidate-RP router for the
Next Available Options:
hold-time
■
480)
priority < 0 to 255 > -- Specify the priority for the Candidate-RP router.
■
source-ip-vlan
■
(PIM-SM must be enabled on this VLAN). (VLAN-ID)
group-prefix
■
(p. 480)
source-ip-vlan
■ [no] router pim bsr-candidate source-ip-vlan VLAN-ID
Specify the VLAN to use as a source for Candidate-BSR router IP address
(PIM-SM must be enabled on this VLAN).
■ [no] router pim rp-candidate source-ip-vlan VLAN-ID
Specify the VLAN to use as a source for Candidate-RP router IP address
(PIM-SM must be enabled on this VLAN).
Next Available Option:
group-prefix
■
(p. 480)
spt-threshold
■ [no] router pim spt-threshold
Usage: [no] spt-threshold
Description: Specify whether switching to the Shortest Path Tree is enabled
© 2009 Hewlett-Packard Development Company, L.P.
command to remove specific multicast group or disable the router
to be a Candidate-RP.
NOTE: It is recommended that the same routing switch is configured
as the Candidate-BSR and the Candidate-RP.
as the Candidate-RP address.
the multicast group(s) the router uses to advertise in association
with the Candidate-RP address.
BSR in C-RP-Adv messages. This tells the BSR for how long it
should consider the sending Candidate-RP router to be operative.
The default is 150 seconds.
Note: This value is set to '0' when local system is not a
Candidate-RP.
local PIM-SM domain. The smaller value means the higher priority.
The default is 192.
< 30 to 255 > -- Specify the hold time value to be send in C-RP-Adv messages.
-- Specify the VLAN to use as a source for Candidate-RP router IP address
-- Specify the multicast group prefix to associate with the Candidate-RP router.
-- Specify the multicast group prefix to associate with the Candidate-RP router.
or disabled on the router. Default is 'enabled'.
(p. 484)
(p. 488)
router
(p.
488