Sntp - HP ProCurve 5400zl Reference Manual

OVERVIEW
Category:
Primary context:
Related Commands
Usage: [no] sntp [broadcast|unicast]
[no] sntp server priority <PRIORITY> <IP-ADDR | IPV6-ADDR> [version]
sntp poll-interval <30-720>
Description: Configure the Simple Network Time Protocol (SNTP).
COMMAND STRUCTURE

■ sntp

broadcast
■ sntp poll-interval
SNTP (p. 635)
■ [no] sntp server
priority < 1 to 3 > -- Priority of the Server Address. (NUMBER)
■
ipaddr
■
version
■
ipv6addr
■
version
■
■ sntp unicast
COMMAND DETAILS
broadcast (p. 634)
ipaddr (p. 635)
ipv6addr (p. 635)
broadcast
■ sntp broadcast
Operate in broadcast mode
© 2009 Hewlett-Packard Development Company, L.P.
Switch Management
config
show sntp (page 592)
timesync (page 689)
The first version of the command specifies whether the
switch operates in broadcast or unicast mode. If no mode is
specified then the mode defaults to broadcast.
The second version of the command adds or deletes an SNTP
server to or from the configuration. The maximum number of
SNTP servers that can be configured is 3. Version can have
a value between 1 and 7. If no version is specified then a
default value of 3 is used.Priority specifies the order in
which the configured servers are polled for getting the time.
It can have a value between 1 and 3.
The final version of this command sets the SNTP poll
interval, which specifies the amount of time between updates
of the system clock via SNTP.
-- Operate in broadcast mode
< 30 to 720 > -- The amount of time between updates of the system clock via
-- Configure SNTP servers to poll time from.
-- SNTP server IPv4 address. (IP-ADDR)
< 1 to 7 > -- Version of the SNTP server.
-- SNTP server IPv6 address. (IPV6-ADDR)
< 1 to 7 > -- Version of the SNTP server.
-- Operate in unicast mode
poll-interval (p. 635)
priority (p. 635)
server (p. 635)
(p. 634)
(p. 635)
(p. 635)
(p. 635)
(p. 635)
(p. 635)
(p. 635)
sntp
(p. 635)
unicast (p. 635)
version (p. 635)
634