HP ProCurve 5400zl Reference Manual page 717

Command Line Interface Reference Guide
Usage: [no] ip irdp <multicast|broadcast>
Description: Specify the destination address to be used for router
Supported Values:
■ multicast -- Send advertisements to all-hosts multicast address.
■ broadcast -- Send advertisements to broadcast address.
advertise-interval
■ vlan VLAN-ID vrrp vrid < 1 to 255 > advertise-interval < 1 to 255 >
Usage: vrrp vrid <VRID> advertise-interval <1-255>
Description: Set time interval (in seconds) between sending VRRP advertisement
Range: < 1 to 255 >
all
■ [no] vlan VLAN-ID ip ospf all
Process the request for all IP addresses.
Next Available Options:
passive
■
area -- Specify an OSPF
■
authentication-key
■
authentication
■
md5-auth-key-chain
■
cost < 1 to 65535 > -- Set metric of this
■
dead-interval
■
hello-interval
■
priority < 0 to 255 > -- Set priority of this router as a designated
■
retransmit-interval
■
transit-delay
■
■ [no] vlan VLAN-ID ip rip all
Process the request for all IP addresses.
Next Available Options:
authentication-type
■
authentication-key
■
metric < 1 to 15 > -- Set metric for this
■
poison-reverse
■
receive < V1-only | V2-only | V1-or-V2 | ... > -- Define RIP version for incoming
■
send < disabled | V1-only | V1-compatible-V2 | ... > -- Define RIP version for outgoing
■
747)
© 2009 Hewlett-Packard Development Company, L.P.
advertisements.
It has to be either multicast or broadcast. If the value
of this object is 'multicast' (the default), router
advertisements will be sent to the all-hosts multicast
address, 224.0.0.1. If the value of this object is 'broadcast',
router advertisements sent on this interface will be sent to
the limitied broadcast address, 255.255.255.255.
messages. The default value is one second.
-- Configures an ospf interface as passive.
area.(p. 716)
-- Set simple authentication method and
-- Disable authentication.(p. 717)
-- Set MD5 authentication method and key
< 1 to 65535 > -- Set dead interval in seconds; the default is
< 1 to 65535 > -- Set hello interval in seconds; the default is
< 1 to 3600 > -- Set retransmit interval in seconds; the default is
< 1 to 3600 > -- Set transit delay in seconds; the default is
< none | text > -- Set authentication type used on this
-- Set RIP authentication key (maximum 16
-- Enable/disable poison reverse on this
(p. 739)
key.(p. 717)
interface.(p. 721)
interface.(p. 734)
interface.(p. 741)
chain.(p. 734)
40.(p. 721)
10.(p. 725)
router.(p. 742)
5.(p. 746)
1.(p. 749)
interface.(p. 718)
characters).(p. 717)
packets.(p. 745)
packets.(p.
vlan
715