HP ProCurve 5400zl Reference Manual page 751

Command line interface, switch software
Hide thumbs Also See for ProCurve 5400zl:
Table of Contents

Advertisement

Command Line Interface Reference Guide
transit-delay
■ vlan VLAN-ID ip ospf transit-delay < 1 to 3600 >
Set transit delay in seconds; the default is 1.
Range: < 1 to 3600 >
■ vlan VLAN-ID ip ospf IP-ADDR transit-delay < 1 to 3600 >
Set transit delay in seconds; the default is 1.
Range: < 1 to 3600 >
■ vlan VLAN-ID ip ospf all transit-delay < 1 to 3600 >
Set transit delay in seconds; the default is 1.
Range: < 1 to 3600 >
ttl-threshold
■ vlan VLAN-ID ip pim-dense ttl-threshold < 0 to 255 >
Usage: ip pim-dense ttl-threshold <0-255>
Description: Set the Time To Live in a PIM-DM State Refresh message at
Range: < 0 to 255 >
■ vlan VLAN-ID ip mroute ttl-threshold < 0 to 255 >
Usage: ip mroute ttl-threshold <0-255>
Description: Set the multicast datagram TTL threshold for the interface.
Range: < 0 to 255 >
udp
■ [no] vlan VLAN-ID ip forward-protocol udp
Usage: [no] ip forward-protocol udp IP-ADDR PORT-NUM|PORT-NAME
Description: Add or remove a UDP server address for the VLAN. The
Next Available Option:
ip-addr
-- IP address of the protocol server. (IP-ADDR)
unblock
■ vlan VLAN-ID connection-rate-filter unblock
Resets a host previously blocked by the connection rate filter
© 2009 Hewlett-Packard Development Company, L.P.
which it is not forwarded on this interface. Default is 0.
Any IP multicast datagrams with a TTL less than this threshold
will not be forwarded out the interface. The default value of 0
means all multicast packets are forwarded out the interface.
broadcast
packets received by the switch on this VLAN are to
be forwarded to the specified application server.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
(p. 729)
vlan
749

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 3500ylProcurve 8200zl6200yl

Table of Contents