HP ProCurve 5400zl Reference Manual page 492

Command Line Interface Reference Guide
Supported Values:
■ virtual-interface-state-change
■ neighbor-state-change
■ virtual-neighbor-state-change
■ interface-config-error
■ virtual-interface-config-error
■ interface-authentication-failure
■ virtual-interface-authentication-failure
■ interface-receive-bad-packet
■ virtual-interface-receive-bad-packet
■ interface-retransmit-packet
■ virtual-interface-retransmit-packet
■ originate-lsa
■ originate-maxage-lsa
■ interface-state-change
■ all
■ [no] router pim trap < neighbor-loss | hardware-mrt-full | software-mrt-full | ... >
© 2009 Hewlett-Packard Development Company, L.P.
Dr, or Backup).
- 'virtual-interface-state-change' signifies the same change in the
state of a virtual OSPF interface.
- 'neighbor-state-change' signifies that there has been a change in
the state of a non-virtual OSPF neighbor. This trap is generated
when the neighbor state regresses (e.g., goes from Attempt or Full
to 1-Way or Down) or progresses to a terminal state (e.g., 2-Way
or Full).
- 'virtual-neighbor-state-change' signifies the same change in the
state of a virtual OSPF neighbor.
- 'interface-config-error' signifies that a packet has been received
on a non-virtual interface from a router whose configuration
parameters conflict with this router's configuration parameters.
- 'virtual-interface-config-error' signifies the same condition on a
virtual interface.
- 'interface-authentication-failure' signifies that a packet has
been received on a non-virtual interface from a router whose
authentication key or authentication type conflicts with this
router's authentication key or authentication type.
- 'virtual-interface-authentication-failure' signifies the same
condition on a virtual interface.
- 'interface-receive-bad-packet' signifies that an OSPF packet has
been received on a non-virtual interface that cannot be parsed.
- 'virtual-interface-receive-bad-packet' signifies the same
condition on a virtual interface.
- 'interface-retransmit-packet' signifies than an OSPF packet has
been retransmitted on a non-virtual interface.
- 'virtual-interface-retransmit-packet' signifies the same condition
on a virtual interface.
- 'originate-lsa' signifies that a new LSA has been originated by
this router. This trap is not invoked for simple refreshes of
LSAs, but instead will only be invoked when an LSA is
(re)originated due to a topology change. Additionally, this trap
does not include LSAs that are being flushed because they have
expired.
- 'originate-maxage-lsa' signifies that one of the LSA in the
router's link-state database has expired.
If 'all' is specified in place of a trap name then all the traps
are affected by the command.
router
490