Command Line Interface Reference Guide
■ none -- Do not use authentication.
■ text -- Use simple password.
auth-key-text
■ vlan VLAN-ID ip rip authentication-key OCTET-STR
Set RIP authentication key (maximum 16 characters).
■ vlan VLAN-ID ip rip IP-ADDR authentication-key OCTET-STR
Set RIP authentication key (maximum 16 characters).
■ vlan VLAN-ID ip rip all authentication-key OCTET-STR
Set RIP authentication key (maximum 16 characters).
auto
■ vlan VLAN-ID auto [ETHERNET] PORT-LIST
Usage: [no] auto [ethernet] PORT-LIST
Description: Cause each port identified in the port list to learn its
■ vlan VLAN-ID ip igmp auto [ETHERNET] PORT-LIST
Usage: ip igmp auto [ethernet] PORT-LIST
Description: Instruct the device to monitor incoming multicast traffic
■ vlan VLAN-ID ipv6 mld auto [ETHERNET] PORT-LIST
Usage: vlan < vid > ipv6 mld auto < port-list >
Description: Instruct the device to monitor incoming multicast traffic
autoconfig
■ [no] vlan VLAN-ID ipv6 address autoconfig
Automatic address configuration.
backbone
■ vlan VLAN-ID ip ospf area backbone
The backbone area (the same as 0.0.0.0).
■ vlan VLAN-ID ip ospf IP-ADDR area backbone
The backbone area (the same as 0.0.0.0).
© 2009 Hewlett-Packard Development Company, L.P.
VLAN membership using the GARP VLAN Registration Protocol
(GVRP). This command is only valid when GVRP is enabled.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
on the specified ports (this is the default behavior).
feature is configured on a per-VLAN basis.
on the specified ports (this is the default behavior).
feature is configured on a per-VLAN basis.
vlan
This
This
719