HP ProCurve 5400zl Reference Manual page 76

Command Line Interface Reference Guide
module. If a second management module is not present in the switch, the
system is rebooted.
config
■ boot system flash < primary | secondary > config < config | config1 >
Specify configuration file to use on boot.
Supported Values:
■ config
■ config1
flash
■ boot system flash < primary | secondary >
Specify boot image to use after reboot.
Supported Values:
■ primary -- Primary flash image.
■ secondary -- Secondary flash image.
Next Available Option:
config < config | config1 > -- Specify configuration file to use on
■
■ boot set-default flash < primary | secondary >
Specify the default flash boot image.
Supported Values:
■ primary -- Primary flash image.
■ secondary -- Secondary flash image.
set-default
■ boot set-default
Specify the default flash boot image. Sets the default flash for the
next boot to primary or secondary. You will see this message:
"This command changes the location of the default boot. This command
will change the default flash image to boot from <flash chosen>.
Hereafter, 'reload' and 'boot' commands will boot from <flash chosen>.
Do you want to continue [y/n]?"
Next Available Option:
flash < primary | secondary > -- Specify the default flash boot
■
standby
■ boot standby
Reboot the standby management module.
If the standby module is not present, this message displays: "The other
management module is not present."
© 2009 Hewlett-Packard Development Company, L.P.
image.(p. 74)
The switch does not switchover.
boot.(p. 74)
boot
74