HP ProCurve 5400zl Series Replacement Instructions

Fan tray replacement

Hide thumbs Also See for ProCurve 5400zl Series:

Replacement Fan Tray Instructions

for the ProCurve Series 5400zl Switches

The fan tray is hot swappable. It can be removed and replaced without removing power from the

switch. However, install the new fan tray immediately (within two minutes) after removing the old

fan tray to avoid overheating and a switch shutdown (within three minutes).

Release the two retaining screws

Grasp the handle and remove the old fan tray

Install the new fan tray

Tighten the two retaining screws

W A R N I N G

To avoid contact with spinning fans, if you are hot swapping out the fan tray assembly, pull

the assembly out one-inch and allow the fans to stop rotating (approximately 20 seconds)

before pulling it all the way out.

Retaining Screws

Handle

Table of Contents

Do you have a question about the ProCurve 5400zl Series and is the answer not in the manual?

Page 1 Replacement Fan Tray Instructions for the ProCurve Series 5400zl Switches The fan tray is hot swappable. It can be removed and replaced without removing power from the switch. However, install the new fan tray immediately (within two minutes) after removing the old fan tray to avoid overheating and a switch shutdown (within three minutes).
Page 2 © Copyright 2006 Hewlett-Packard Develop- ment Company, LP. All rights reserved. The information contained herein is subject to change without notice. This document contains proprietary information, which is protected by copyright. No part of this document may be photocopied, reproduced, or Part Number: 5991-2183 translated into another language without the January 2006...