HP ProCurve 5400zl Reference Manual page 359

Command Line Interface Reference Guide
fast-start-count
■ lldp fast-start-count < 1 to 10 >
Usage: lldp fast-start-count <1-10>
Description: Set MED fast-start count in seconds.
Range: < 1 to 10 >
holdtime-multiplier
■ lldp holdtime-multiplier < 2 to 10 >
Usage: lldp holdtime-multiplier <2-10>
Description: Set holdtime-multipler between <2-10>; the default is 4.
Range: < 2 to 10 >
ipAddrEnable
■ [no] lldp config [ETHERNET] PORT-LIST ipAddrEnable
Set IP ADDR to be enabled.
Next Available Options:
lldp-ip -- Set IPV4 ADDR to be enabled. (IP-ADDR)
■
lldp-ipv6
■
lldp-ip
■ [no] lldp config [ETHERNET] PORT-LIST ipAddrEnable IP-ADDR
Set IPV4 ADDR to be enabled.
lldp-ipv6
■ [no] lldp config [ETHERNET] PORT-LIST ipAddrEnable IPV6-ADDR
Set IPV6 ADDR to be enabled.
medPortLocation
■ [no] lldp config [ETHERNET] PORT-LIST medPortLocation
Configure location-id information to be advertised.
Next Available Options:
civic-addr
■
elin-addr
■
medTlvEnable
■ [no] lldp config [ETHERNET] PORT-LIST medTlvEnable < capabilities | network_policy | location_id
| ... >
© 2009 Hewlett-Packard Development Company, L.P.
-- Set IPV6 ADDR to be enabled. (IPV6-ADDR)
-- Specify the civic location-id information to be
-- Specify the elin address location to be advertised.
(p. 357)
(p. 357)
advertised(p. 355)
(p. 356)
lldp
357