HP ProCurve 5400zl Reference Manual page 217

Command Line Interface Reference Guide
Usage: [no] ip access-group <ACL-ID> in
Description: Apply the specified access control list to inbound
Next Available Option:
direction
■
■ interface [ETHERNET] PORT-LIST ipv6 access-group ACCESS-GROUP
Usage: [no] ipv6 access-group <name> in
Description: Apply a IPV6 ACl on the interface .
Parameters:
o name - ipv6 acl name.
o in - Apply the ipv6 acl as inbound.
Next Available Option:
in -- Match inbound packets.
■
■ [no] interface vlan VLAN-ID ip access-group ACCESS-GROUP
Usage: [no] ip access-group <ACL-ID> <in|out>
in
out
vlan
connection-rate-filter Manage new conection rates originating in this VLAN
Description: Apply the specified access control list on this VLAN interface.
Next Available Option:
direction
■
■ [no] interface vlan VLAN-ID ipv6 access-group ACCESS-GROUP
Usage: [no] ipv6 access-group <name> vlan
Description: Apply a IPV6 ACl on a VLAN.
Parameters:
o name - ipv6 acl name.
o vlan - Apply the ipv6 acl as VLAN acl.
Next Available Option:
vlan -- VLAN acl.
■
■ [no] interface svlan VLAN-ID ip access-group ACCESS-GROUP
© 2009 Hewlett-Packard Development Company, L.P.
packets on this INTERFACE list.
control list ACL-ID must be defined before it can be applied.
Connection rate filter ACLs cannot be applied on this
INTERFACE list.
< in > -- (p. 231)
(p. 238)
Match packets this device will route to another VLAN
Match packets this device will route onto this VLAN
Match packets that originate within this VLAN
The ACL can match either packets that are routed from this VLAN
to another VLAN, packets that will be routed from another VLAN
to this VLAN, packets that originate on this VLAN, or it can
manage new connection rates for virus throttling.Connection rate
filter ACLs should be applied as connection-rate-filter only.
< in | out | connection-rate-filter | ... > --
(p. 282)
The access
(p. 231)
interface
215