Command Line Interface Reference Guide
following syntax:
Only link-local addreses are configured without PREFIX-LEN as below:
Multiple addresses may be configured on a single VLAN.
Next Available Options:
autoconfig
■
dhcp
-- Configure a DHCPv6
■
ipv6-addr
■
ipv6-addr/mask
■
(IPV6-ADDR/PREFIX-LEN)
all
■ svlan VLAN-ID connection-rate-filter unblock all
Resets all previously blocked by the connection rate filter
■ svlan VLAN-ID monitor all < In | Out | Both >
Monitor all traffic.
Supported Values:
■ In -- Monitor all inbound traffic
■ Out -- Monitor all outbound traffic
■ Both -- Monitor all inbound and outbound traffic
Next Available Option:
mirror
-- Mirror
■
anycast
■ [no] svlan VLAN-ID ipv6 address IPV6-ADDR/PREFIX-LEN anycast
Address that is assigned to a set of interfaces that typically belong to different
nodes
auto
■ svlan VLAN-ID auto [ETHERNET] PORT-LIST
Usage: [no] auto [ethernet] PORT-LIST
Description: Cause each port identified in the port list to learn its
autoconfig
■ [no] svlan VLAN-ID ipv6 address autoconfig
© 2009 Hewlett-Packard Development Company, L.P.
ipv6 address 1234:abcd::5678/40
ipv6 address 2001:0db8:1:1:ffff:ffff:ffff:fffe/64 anycast
ipv6 address 2001:0db8:0:1::/64 eui-64
ipv6 address FE80:0:0:0:0123:0456:0789:0abc link-local
-- Automatic address
client.(p. 666)
-- Configure a link-local IPv6 address. (IPV6-ADDR)
-- Configure IPv6 address represented in CIDR notation.
(p. 668)
destination.(p. 669)
VLAN membership using the GARP VLAN Registration Protocol
(GVRP). This command is only valid when GVRP is enabled.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
configuration.(p. 665)
(p. 668)
svlan
665